Page 121 - RoboCilindri, RCP2-RCP3, robocilindri, sinta,

Model Selection Reference (Push Force)Selection Guide (Push Force and Electric Current Limitation Correlation Graph)When using the slider type for the pressing operation, limit the pressing current to prevent anti-moment generated by push force from exceeding 80% of catalog spec rating for moment (Ma, Mb).To calculate moment, use the guide moment action position shown in the figure below, and consider the amount of offset at the push force action position.Be aware that, if excess force above the rated moment is applied, the guide can be damaged and its use life can be shortened. Therefore, carefully set the current with safety in mind.RCP3 SeriesSlider TypeMoment offset reference pointSA3C: h = 29.5mm SA4C: h = 36.5mm SA5C: h = 43.5mm SA6C: h = 47.0mmWhen using slider type for the pressing operation, use setting to ensure that anti-moment generated by push force does not exceed 80% of catalog spec moment tolerance.Example of calculations:When executing 30N pressing with RCP-3SA6C (Lead 12) type, and performing pressing at 30N,the moment received by the guide is Ma = (47 + 50) x 30= 2910 (N mm) = 2.91 (N m). 80% of which is 3.448, which is greater than the actual moment load received bythe guide (2.91). Therefore, it can be decided that this moment load can be used.SA3C Type30N 50mmSA4C Type47mmGuide Work PointPush force and current limit correlation graph * In the table below, standard figures are shown. Actual figures will differ slightly.50 45 40 35 30 25 20 15 105025 30 35 40 45 50 55Electric Current Limit (%)160 140 120 10080 60 40 20025 30 35 40 45 50 55Electric Current Limit (%)SA5C/SA6C Type200 180 160 140 120 10080 60 40 20025 30 35 40 45 50 55Electric Current Limit (%)Appendix: - 65 Technical Reference/InformationPushing Force (N) Pushing Force (N)Pushing Force (N)hSA3-2SA4-2.5SA3-4SA4-5SA3-6SA4-10SA5-3/SA6-3SA5-6/SA6-6SA5-12/SA6-12