Page 123 - RoboCilindri, RCP2-RCP3, robocilindri, sinta,

Model Selection Reference (Push Force)Selection Guide (Push Force and Electric Current Limitation Correlation Graph)When using the slider type for the pressing operation, limit the pressing current to prevent anti-moment generated by the push force from exceeding 80% of the catalog spec rating for moment (Ma, Mb).To calculate moment, use the guide moment action position shown in the figure below, and consider the amount of offset at the push force action position.Be aware that, if excess force above the rated moment is applied, the guide can be damaged and its use life can be shortened. Therefore, carefully set the current with safety in mind.RCP2 SeriesSlider TypeSA5C: h = 39mm SA6C: h = 40mm SA7C: h = 43mm SS7C: h = 36mm SS8C: h = 48mmCaution: Pressing operations cannot be perfomed for Belt type (BA6/BA7). Note: The movement speed duringpressing is fixed at 20mm/s.Example of calculations:With the RCP2-SS7C type, and using the position in the figure at right for 100N pressing,the moment received by the guide is Ma = (36 + 50) x 100 = 8600 (N mm)= 8.6 (N m).The SS rated moment is Ma = 14.7 (N m)and 14.7 x 0.8 = 11.76 > 8.6, which means it is OK.Also, when pressing generates moment Mb, use the overhang calculation to similarly confirm that the moment is within 80% of the rated moment.SA5C/SA6C/SS7C TypeSA7C TypePush force and current limit correlation graph * In the table below, standard figures are shown. Actual figures will differ slightly.350 300 250 200 150 10050 00 10 20 30 40 50 60 70Electric Current Limit (%)800 700 600 500 400 300 200 10000 10 20 30 40 50 60 70 Electric Current Limit (%)SS8C Type800 700 600 500 400 300 200 10000 10 20 30 40 50 60 70 Electric Current Limit (%)Appendix: - 67 Technical Reference/InformationPushing Force (N) Pushing Force (N)Pushing Force (N)50mmhSA7C-4SA5C-3, SA6C-3, SS7C-3SA7C-8SA5C-6, SA6C-6, SS7C-6SA7C-16SA5C-12, SA6C-12, SS7C-12SS8C-5SS8C-10SS8C-20