Page 11 - RoboCilindri, RCP5, robocilindri, sinta,

OptionBrakeOption code: BOptional cable exit direction Option code:CJT CJR CJL CJB CJOSide-mounted motor direction Option code: ML/MR* Be sure to specify either “ML” or “MR” for the side-mounted motor type.Non-motor end specification Option code: NMFlangeOption code: FLTip Adapter (Flange)Option code: FFATip Adapter (Internal thread) Option code: NFATip Adapter (Keyway)Option code: KFAActuator OptionsApplicable models DescriptionApplicable models DescriptionMotor coupled typeTop (Option code: CJT)Left (Option code: CJL)Right (Option code: CJR)Bottom (Option code: CJB)* View from the rear of the actuator (motor side)* View from the front of the actuatorApplicable models DescriptionRCP5-RA8R/RA10RThe motor is side-mounted to the left (standard) Optioncode: MLApplicable models DescriptionApplicable models DescriptionApplicable models DescriptionApplicable models DescriptionApplicable models DescriptionThe motor is side-mounted to the right Optioncode: MRMotorMotorAll modelsA mechanism that is used to hold the slider or rod in place when the actuator is used vertically, so that it will not drop and damage the work part, etc., when the power or servo is turned off.RCP5-RA8C/RA10C/RA8R/RA10RSelect this option if you want to change the exit direction of the motor/encoder cables to the top, bottom, left or right.Side-mounted motor typeTop (Option code: CJT)Outside (Option code: CJO)Bottom (Option code: CJB)respectively, as viewed from the motor side of the actuator.All modelsSelect this option if you want to change the home position of the actuator's slider or rod from the normal position (the motor end) to the front end.RCP5-RA4C/RA6C/RA7C/RA8C/RA8R/RA10C/RA10RA bracket that is used to secure a rod actuator from the actuator side. The flange can be purchased separately later. * For dimensions on each model, check on P. 59.RCP5-RA4C/RA6C/RA7CAn adapter that is used to install jigs, etc. on the rod tip using four bolts. * For dimensions on each model, check on P. 59.RCP5-RA4C/RA6C/RA7CAn adapter that is used to install jigs, etc. on the rod tip using a bolt. * For dimensions on each model, check on P. 60.RCP5-RA4C/RA6C/RA7CAn adapter that is used to install jigs, etc. on the rod tip using a bolt and parallel key. * For dimensions on each model, check on P. 60.10