Page 14 - RoboCilindri, Controller, robocilindri, sinta,

Slider TypeMiniStandardControllers IntegratedRod TypeMiniStandardControllers IntegratedTable/Arm /Flat TypeMini StandardGripper/ Rotary TypeLinear Motor TypeCleanroom TypeSplash-ProofControllersPMEC /AMECPSEP /ASEPROBO NETERC2 PCON ACON SCON PSEL ASEL SSEL XSELPulse MotorServo Motor (24V)Servo Motor (230V)Linear MotorModel C/CW3-position controller for RCP2/RCP3 Position ControllerModel C/CW3-position controller for RCA/RCA2/RCL Position ControllerPSEP / ASEP ControllerFeature1 Can operate with same signal as a solenoid valve.The signal that operates the actuator is the same as the signal that operates the air cylinder. Therefore, the PLC program currently in use can be used without modification even if the air cylinder is replaced by an electric-powered cylinder. Either a single solenoid or a double solenoid may be used.2 Establishes a dustproof type that supports IP53.We provide dustproof type controllers with an IP53 equivalent (*1) protection structure, sothat the controller can be mounted outside the control panel. (1) Bottom surface excluded.3 Provides the simple absolute type that can be operated immediately upon power-ON without homing.Since the simple absolute type can store the current position with the assistance of the absolute battery unit during power-up or after the emergency stop is deactivated; it can start the next operation at that position.Signal ONSignal OFFExtendedRetracted(Note 1) When the actuator is connected to the simple absolute type controller, the model is considered an incremental model.(Note 2) It can not be used for the linear servo type.The absolute battery unit is required to place below the SEP controller due to the counter measures against heat.SEP controllerAbsolute battery unit4 Pushing and intermediate stop operation is available.Like air cylinders, the pushing operation is available. In this operation, you can stop with a rod being pushed to a workpiece.Since the force for the push operation is adjustable within a range between 20 to 70 % of the maximum pushing force and a signal is generated when it reaches the specified pushing force, it can be used to determine clamping or size of workpieces.5 Easy data entry with the dedicated touch panel teaching unit.Data, such as setting target positions or pushing force, are easily entered with the optional touch panel teaching model: CON-PT.Since the touch panel teaching unit provides an interactive menu and can be controlled directly on the screen, you can operate intuitively with no assistance from operation manuals.Push force is adjustable within the rangeof 20 to 70% of the maximum pushing force487 PSEP / ASEP